APPLICATION

Servers, Data centers, Critical network devices, Sensitive electronic equipment, Telecom...

  
KEY FEATURES

True online double conversion technology
Wide input voltage range
Zero transfer time
Protection against all types of power problems
No add-on CNTL unit required for parallel connection
Low initial investment and flexible for future expansion
Highest reliability and maximum performance for power sharing and redundancy
Equipped with Maintenance Bypass Switch

The best charger design to recharge low battery as quickly as possible with out damaging batteries in 2 amp up to 8 amp and 240 VDC. Allowing 90% recharge in as little as 10 Hours after a total drain.

Audible and Visual Over-load indicators:
The incorporated LED over load indicator prevents ups overloads and premature failure of the UPS.

N+1 Parallel Redundancy:
Allows a 6 kva to grow upto 18kva or 12kva with 6 kva redundancy and a 20 kva to 60 kva or 40 kva with 20 Kva redundancy allowing user to add capacity as needed and lower investment.

Simplified board separation:
Dependent on the Units all operation are separated into 5 pcb boards allowing quick respond to damages and provides our valued dealers with simplified inventory and faster service to the end users.

Dynamic Bypass:
Automatic dynamic Bypass and manual Bypass provide a loop to repair UPS with out having to disconnect loads ideal for non stop computing for critical applications.

SNMP Slot:
Provides remote monitoring and control of UPS where a PC is not present or where this function is needed to be separated.

IBM AS 400 Dry Contact card:
Optional card to communicate in IBM AS 400 Protols

Sine-wave output:
True sine-wave output with a 3% THD on batteries. This feature provides dependable and compatible power for your most critical applications.

True double conversion technology with zero Transfer Time:
This advance design provides the closest you can get to Pure constant power in the industry

TECHNICAL SPECIFICATIONS:

Model		C6KVA/C6KS	C10KVA/C10KS
Rated Power	VA/W	6kVA/4.2kW	10kVA/7kW
Input	Nominal Voltage	220VAC
	Voltage Range	176 ~ 276VAC
	Frequency Range	46 ~ 54Hz
	Power Factor	0.98
	Connection	Hardwired
Output	Voltage	220VAC ±1%
	Frequency	50Hz ±0.1% ( Battery mode)
	Waveform	Sine Wave
	Power factor	0.7
	Voltage Distortion	2% under linear load
	Overload Capability	105% ~ 130% for 10 min., ³130% for 1 min.
	Current Crest Ratio	3:1 max.
	Connection	Hardwired
Battery	Type	Sealed, Maintenance free, Lead-Acid
	Quantity	20 pieces
	Back-up time (full load)	7 min	5 min
	Recharge time	8 hrs to 90% of capacity after full load discharge
Transfer time		0 ms
Maintenance Bypass Switch		Yes
LED indicators	Status	Load level/Battery level, Battery , Utility power, Inverter, Bypass, Overload, Fault
Audible alarm	Bypass	Alarm beeps every two minutes
	Battery discharge	Alarm beeps every four seconds, every second if battery low
	Overload	Alarm beeps two for every second
	Fault	Alarm beeps continuously
Acoustic noise	At 1 meter distance	£ 55 dBA
Communications	DB-9 Port	RS232 serial interface
	Intelligent Slot	Options: WebPower, AS400 or WinPower CMC
Parallel Port		up to three units in parallel for power redundancy and load sharing
Environmental	Operating temperature	0 ~ 40°C
	Operating humidity	20% ~ 90% non-condensing
Weight	Net (kg)	35/84	38/93
Dimensions	W x D x H (mm)	260 x 570 x 717